wla 60DW520, Инструкция по эксплуатации, Страница: 58 / 89

19
Built-In Installation
(for the integrated model)
Step 1. Selecting the best location for the dishwasher
The installation position of dishwasher should be near the existing inlet and drain hoses
and power cord.
Illustrations of cabinet dimensions and installation position of the dishwasher.
1.
Less than 5 mm between the top of dishwasher and cabinet and the outer door
aligned to cabinet.
90 ° 90 °
580mm 580mm
820mm 820mm
100 100
Electrical, drain
and water supply
line entrances
Electrical, drain
and water supply
line entrances
Space between cabinet
bottom and floor
Space between cabinet
bottom and floor
600 mm(
for 60cm model
)
450
mm
(
for 45cm model
)
80 80
Underneath existing work top
(
When fitting beneath a work top)
In most modern fitted kitchens there is only one
single work top under which cabinets and
electrical appliances are fitted. In this case remove
the work top of the dishwasher by unscrewing the
screws under the rear edge of the top (
a ).
a
a
b
b
After removing the work top, the screws must be screwed again under the rear edge
of the top (
b
).
Attention
The height will then be reduced to 815 mm, as scheduled by the International
Regulations (ISO) and the dishwasher will fit perfectly under the kitchen working top
厨下式用此页替换
21
2.
If dishwasher is in stalled at the corner of the cabinet,
there should be some space when the door is opened.
Cabinet Dishwasher
Door of
dishwasher
Minimum space
of 50mm
NOTE
:
Depending on where your electrical outlet is, you may
need to cut a hole in the opposite cabinet side.
Step 3. Dishwasher installation steps
1.
Affix the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface.
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into position.
6. Level the dishwasher. The rear foot can be adjusted from the front of the
dishwasher by turning the Philips screw in the middle of the base of dishwasher
use an Philips screw. To adjust the front feet, use a flat screw driver and turn the
front feet until the dishwasher is level.
7. Adjust the tension of the door springs by using an Allen key turning in a clockwise
motion to tighten the left and right door springs. Failure to do this could cause
damage to your dishwasher.
8.
The dishwasher must be secured in place. Fix the side with screws.
9