4
2. Installation
2.1 Before Installation:
1.
Open the carton and take out the lift. Check the lift and accessories to
see if they are in well condition.
2.
Hold the lift and connect to proper power. Run it up and down be the
equipped IR and RF or remote control to see if it works normally.
3.
Measure carefully and make sure there will be enough ceiling opening
space. Suggested space is: L*W*H: 550mm*550mm*H (H=170cm +
ceiling mount projector height).
4.
A power socket will be needed in the ceiling opening.
5.
Choose proper wire for the projector and start wire routing.
Caution:
1.
Must hang (suspend) the lift before power on. Lift must be able to drop down by gravity. Running without
suspension will damage the parts inside and might hurt installer.
2.
The installation must be done by two or more professional technicians.
3.
Make sure the ceiling is strong. Lift must be installed on a reinforced level ceiling which can support at
least three times of the combined weight of lift and the projector.
2.2 Lift installation:
Refer to the drawings below, drill 4 holes at proper position. Install the equipped M8 expansion screws to the
holes, hang on the lift and then tighten the screw nuts.
