\Handouts\CMCConvertibleStand
02/15/08
--
Wizard™ International, Inc., 4600 116th St. SW, PO Box 66, Mukilteo, WA 98275 888/855-3335 Fax: 425/551-4350
wizardint.com
Dimensions
You have two options when assembling the convertible stand: Angled and Upright. Because both
use the same Cradle Side piece, you will need to make this determination about halfway through the
installation process. The Driver Pak Basket is on the left side in either assembly.
The Angled Convertible Stand (Fig A) with the Wizard installed is 50” Deep, and 72” wide, bottom
edge is 36” High, and lies at a 15 degree angle. This configuration is not recommended for the CMC
Model 8500e.
The Upright Convertible Stand
(Fig B) with the Wizard installed is 38” Deep, and 72” wide, bottom
edge is 29” High, and lies at a 45 degree angle. This configuration can be used with the CMC Model
8500e.
Fig A.
Fig B.
Fig C.
Fig A: Angled Stand. Fig B: Upright Stand. Fig C: Upright Stand with Board Stops for the 8500e.
Attach crossbars
1. Lay out the Base Sides and the crossbars (Fig A). Note that the bar closest to the front of the Base
Side is angled at the top, and the side bar of the Base Side slopes down toward the front. Make sure
to keep the screws and holes for the Driver Pak Basket on the left outside side when assembling (Fig
B).
Fig A.
Fig B.
Fig A: Lay out the Base Sides and the crossbars. Fig B: Note which side of the Base Side is the front, and make sure that
the screws for the Driver Pak Basket is on the left side.