4
WT-1011RC IP65 GSM Remote Controller And Alarm System
WT-1011RC IP65 – USER MANUAL – Rev.1.6 – Technical Support:
COPYRIGHT ©2010 WITURA CORPORATION SDN BHD
Housed in the weather and desk proof IP65 enclosure complete with internal industrial
modem, monitoring controller and flexible operating firmware. It is very easy to setup,
install and use.
Most equipment today does provide some form of alerting signal to interface to
monitoring devices from reporting of various malfunction or abnormalities. There are
various kinds of signal that the equipment can send out, most common of which are
opening or closure of one or more switch relay contact. UPS usually provide signals such
as incoming power fail, battery mode, battery level low, and switchover failure. An air
conditioner system may provide signals such as system on/off, compressor over
temperature, low gas pressure, etc.
Equipments to be monitored are connected to WT-1011RC using these alarm signaling
contacts. WT-1011RC keeps a constant watch over all the contacts. Whenever any
contact input changes status (either from a close to open or from an open state to close
state) it is captured by WT-1011RC. It will then process the input according to the
configuration provided by the user. The correct SMS messages will be sent to 8 mobile
phone users.
WT-1011RC is so fast in capturing the change of status of any signaling contacts that no
event will be missed out up to 2 inputs can be monitored directly. The flexibility of WT-
1011RC is in allowing remote query of input status using SMS.
To change contacting mobile phone number is also very easy. Authorize personal
remotely using SMS command to add, change or delete mobile phone number in WT-
1011RC.
WT-1011RC is a 2 way device. Besides monitoring inputs and act upon such inputs it
also allow mobile phone users to compose SMS messages to it. When WT-1011RC
receives any SMS, it will look its memory bank to see what it is supposed to do and
action according. No action SMS are ignored.
3.1 Standalone Operation
3.2 2 Digital Inputs
3.3 2 Digital Outputs
