Maintenance and disposal
SP
+
en-16
2022-D033540
Revision: 03
7
Maintenance and disposal
z
Be informed of the general safety instructions before beginning work. (see Chapter 2.7
"General safety instructions").
7.1
Maintenance work
7.1.1
Visual inspection
z
Check the entire gearhead for exterior damage.
z
The radial shaft seals are subject to wear. Therefore also check the gearhead for leakage
during each visual inspection.
L
You can find more general information on radial shaft seals on our partner's Internet site at
http://www.simrit.de.
L
Check the mounting position, so that no foreign medium (e.g. oil) has collected on the
output shaft.
7.1.2
Checking the tightening torques
z
Check the tightening torque of the fastening bolts on the gearhead housing.
L
You can find the prescribed tightening torques in Chapter 9.3 "Specifications on mounting
onto a machine", table "Tbl-16".
z
Check the tightening torque of the clamping bolt on the motor mounting.
L
You can find the prescribed tightening torques in Chapter 9.1 "Specifications on mounting
onto a motor", table "Tbl-14".
7.2
Startup after maintenance work
z
Clean the outside of the gearhead.
z
Attach all safety devices.
z
Do a trial run before releasing the gearhead again for operation.
7.3
Maintenance schedule
Maintenance work
At startup
First time after
500 operating
hours
or 3 months
Every
3 months
Yearly
Visual inspection
X
X
X
Checking the
tightening torques
X
X
X
Tbl-10: Maintenance schedule
