Assembly
SP
+
ATEX MC
en-20
2022-D014985
Revision: 07
Pinning the mounted and aligned gearbox (optional)
5.4.3 Mounting with threaded bores
5.5
Components mounted to the output side
The output side has different shapes depending on the product type:
- Smooth shaft
- Shaft with shaft key
- Splined shaft (DIN 5480)
- Blind hollow shaft / hollow shaft / hollow shaft interface / flange hollow shaft
- Flange
- With mounted output pinion
For details on how to mount the
slip-on shaft / hollow shaft / hollow shaft interface
, refer to
the instructions in Chapter 5.5.1 "Mounting with shrink disk".
For details on how to fasten the
flange / flange hollow shaft / keyed hollow shaft
, refer to
the instructions in Chapter 10.3 "Specifications for mounting to the output side".
Slide the washers onto the fastening screws.
Fasten the gearbox to the machine with the
fastening screws through the slotted holes [M].
Optionally, there are two bore holes [N] on the gear housing for pinning
the gearbox to the machine. You can fasten the gearbox to the machine
with cylinder pins.
Drill pin holes into the machine bed according to the bores [N] of the
gear housing.
Ream the bores to the corresponding fit size for the cylinder pins.
For specifications on the cylinder pins, refer to Chapter 10.2
"Specifications for mounting to a machine".
Fasten the gearbox with the cylinder pins.
We recommend doing without washers as long as the
material of the screw surface features sufficient interface
pressure.
Fasten the gearbox to the machine with the fastening screws
through the threaded bores [M].
M
N
M
