Witt WS88, Руководство пользователя

Страница: 53 / 60

~ 53 ~
Drill the holes in the wall, insert the four plastic anchors supplied with the
appliance, and then fix the bracket by using the screws provided.
If the appliance works in re-circulating mode, the air outlet conduit is not
necessary.
If the appliance works in extraction mode, the conduit shall be made inside
the bracket shown in fig. 1.
Insert the perforated steel component into the rear side of the cooker hood,
as shown in fig. 2, making sure to introduce it inside the product as much as
possible, in order to make the cooker hood wall installation easier.
If the appliance works in extraction mode, with the rear outlet located inside
the wall fixed bracket, install the plastic nipple in correspondence to the
motor air outlet flange, as shown in fig. 3.
Hang the appliance to the bracket previously fixed to the wall, making the
bracket pins coincide with the special slots found on the cooker hood, as
shown in fig. 4.
Secure the cooker hood, by inserting the two side screws shown in fig. 5;
check the hood proper flatness while performing this operation.
Carry out the electric connection.
Bring the steel component close to the wall until it is hooked to the wall fixed
bracket ( fig. 6).
If the cooker hood is in re-circulating mode it is necessary to use charcoal
filters, following the steps below.
Remove both the front and rear grease filters, by pulling them as shown in
fig. 8, take the charcoal filters from the carton box and mount them as shown
in fig . 9.