Witt SmartSousVide, Руководство пользователя

Страница: 9 / 12

9
• The clock symbol and 0:05 min. (default) flash. Press the – or + button to set the time delay for the
cooking process in steps of 5 minutes each.
• Press the START/STOP button to confirm.
• The timer symbol and 0:05 min. (default) flash. Press the – or + button to set the desired time duration
for the cooking process in steps of 5 minutes each.
• Press the START/STOP button to confirm.
• Press the START/STOP button again to activate the process.
• The clock symbol and the circular symbol appear and the time display counts down the minutes.
• After time has expired, the instrument will automatically switch on and the cooking process begins.
• After the cooking process is finished, an alarm sounds and the stop symbol appears. The device will
turn off the heater automatically.
During the cooking process
• Press the – or + button to check the remaining delay time/cooking time and target temperature.
• You can stop and restart the cooking process with the START/STOP button.
• Press and hold the START/STOP button for 2 seconds to finish the cooking process and reset all settings.
After finishing the cooking process
• Take the cooked food carefully out of the water.
• Turn off the instrument after use.
• Pull the plug out of the socket, let the instrument cool down and clean it straight after.
Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents. If necessary, turn the
plastic cap anticlockwise and lift the impeller protective cover to remove it.
• To assemble, place the protective cover diagonally and click it firmly. The gap on the cover must be
attached to the raised part. Replace the plastic cap and turn it to lock.
• Keep the device in a dry place.
• Check the appliance for limescale deposits before each use.
• If necessary, descale the applinace as described under descaling.
Descaling
• Place a cooking pot on a surface and fasten the device support on the side of the pot.
• Connect the plug to a wall socket.
• Fill the pot with lukewarm tap water. The water level should be between the MIN and MAX markings.
• Apply a descaler according to manufacturer.
• Slide the red switch to the position „ON“.
• Press the – or + button to set 70°C as target temperature and press the START/STOP button.
• Switch off the instrument after 20 minutes.
• Unplug the instrument and let it cool down. Then rinse the removal parts and the immersion heater
with cold tap water.
Troubleshooting
• Please bear in mind that after the appliance is used for several times, deposits (such as limescale) may
form on the heater and the sensors and this may cause a malfunction. To prevent this, we recommend
adding some citric acid or vinegar to the water during the cooking process so such deposits are
prevented or minimized.
• The appliance is not suitable for preparing, reheating or keeping warm soups, sauces, stews or similar
food. Operate the device only with clean tap water.