Witt 24310030, Инструкции по использованию - Советы по установке

Страница: 17 / 52

17 17
CONNECTION OF THE POWER SUPPLY CABLE
Important! This cooktop must be connected to the electricity supply only by an
authorised person.
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
To connect the supply cable:
•
Unhook the terminal board cover by inserting a screwdriver into the two hooks “ A ”
(fig. 2.1).
• Unscrew the screw “ D ” and open completely the cable clamp “ E ” (figs. 2.2 - 2.3 -
2.4).
• Position the U bolts “ F ” onto terminal board “ G ” (figs. 2.2 - 2.3 - 2.4) according to the
diagrams in fig. 2.5.
• Connect the phase, neutral and earth wires to terminal board “
G
” according to the
diagrams in fig. 2.5.
• Strain the feeder cable and block it with cable clamp “ E ” (by screwing screw “ D ”).
• Close the terminal block cover (check the two hooks “ A ” are correctly hooked).
NOTE: The earth conductor must be left about 3 cm longer than the others.
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws
fixing the cover plate behind the terminal block.
FEEDER CABLE SECTION
“TYPE H05RR-F or H05VV-F”
220-240 V ac 3 x 6 mm
2
(**)
380-415 V 3N ac 5 x 2,5 mm
2
(**)
380-415 V 2N ac 4 x 6 mm
2
(**)
(**) Connection with wall box connection.
– Diversity factor applied.
– A diversity factor may be applied to the
total loading of the appliance only by a
suitably qualified person.
A
Fig. 2.1