www.witeg.de
witeg Labortechnik GmbH, Refrigerated Bath Circulator
15
Use the device only in electric circuits with ground fault circuit interrupter.
Check the power supply cord before you stick it into the electrical outlet.
Do not use power bars to extend the power supply cord.
Only use extension cables with sufficient cable cross section.
Do not touch the device with wet hands during the usage because this might cause an
electrical shock.
If unexpected sound, smell or smog is generated by the device, pull out the main plug and
contact the manufacturer or your supplier immediately.
Disconnect the power supply plug before cleaning or maintenance.
If you use radiation or contaminated samples the responsibility is only up to you.
Warn all attendees if you leave the device unattended.
Pay attention when you lift up the lid, hot condensate may drop down or hot steam could
come out.
Do not clean the scorching ore frozen device.
Pay attention and only work with gloves, otherwise
you may freeze on the device’s metal
parts or get burns.
Do not put thermal-sensitive items at the device.
Use this device only if you read the whole safety instructions.
This device should only used by persons who are familiarized with safety instructions made
for laboratories.
Pay attention that no liquid reaches the controller or inward of the capsule.
You have to keep the device clean if you want to get a longer life of it.
Wear corresponding protective work clothing during the usage.
Pull out the power cable if you didn’t want to use the device for a longer time.
It is important that the device stands up on a horizontal and firm subsurface to avoid
vibrations.
If you set the device in a site with vibrations, make sure that the device can not slip away.
The device could get damaged if the vibrations are to strong.
To avoid heat congestion or fires make sure that there is enough space for air circulations.
Avoid direct solar radiation.
Do not use the device near highly combustible materials.
Do not set the device outdoors.
It is superiorly to set the device in a good illuminated place to avoid accidents engendered
by handling errors.
To set the device in wet or dusty places could cause overheating, short circuits or fires.
Make sure the device stands upright within the last 24 hours.
Do not tilt the device.
