WisyCom MTP40S-US, Руководство пользователя

Страница: 9 / 20

MTP40S-US/USX User Manual
Rev.01
9
Device is forced in bootloader mode to allow FIRMWARE UPDATE .
The following table sums up which parameters can be set and the related range settings.
MENU
PARAM
ETER
MEANING RANGE SETTINGS
TUNING
CH Channel 0 ÷ 59
GR Group 0 ÷ 39 + SYNC GROUP
Freq Frequency
depends on the MTP40S Model:
1 470-640
2 566-798
3 510-698
AUDIO
AF In Gain
Gain of the audio
signal depends on the mic mode setting
(ex. -40dB ÷ 40dB step of 1 dB)
Phase Audio signal phase 0° or 180°
HP Filt. High Pass filter Flat/60/80/120/170/250/400 Hz
Noise R. Noise reduction
ENR: Wisycom Extended-NR,noise optimized
ENC: Wisycom Extended-NC,voice optimized
Limiter Limiter On/Off
RF/BATTERY
RF Power RF Power 10mW or 50mW or 100mW(only USX option)
Battery Battery type Alkaline or NiMH
LED
Led Light
Power switch green
brightness
0 ÷ 16
Led Mode
It defines when the
power switch led
(see Fig. 3) has to
become RED
None: never
ModPeak: when audio get close to saturation
PTT: when the PTT button is pushed
MIC
Mode MIC type
’2 wires’
‘2 wires + bias’
‘3 wires’
‘2 wires & phantom’
‘2 wires + bias & phantom’
PTT Mode
It defines how and
what information
the transmitter has
to send
Disable :when the PTT button is pushed, nothing
happen. (the transmitter sends AF+Tone squelch)
Normal : when the PTT button is pushed, the
transmitter send a different RF signal. According to the
receiver configuration the audio can be
enabled/disable on LINE (and/or COM).
Muting : the transmitter doesn’t send the audio. The
voice is cut, it doesn’t enter to the microphone
No Data : the transmitter sends neither tone squelch
nor battery data.