WisyCom MPR30-IFB, Руководство пользователя

Страница: 8 / 32

MPR30-IFB User Manual
Rev. 03
7
ON Led Indicators (Firmware rel. v1.5)
COLOR WHEN MEANING
Red
During the power up phase The receiver is not ready to use
After the power up phase
The PLL is not locked on the select frequency, wait
for lock ( about 1second or less). If after few
seconds the ON led remains red, contact Wisycom
Fixed Green
After the power up phase
The receiver is locked on the select frequency, the
batteries charge is good (
>25% lifetime)
During a battery charge Charge complete
Slow Blinking
Green
After the power up phase
The receiver is locked on the select frequency, the
batteries charge is low (
<25% lifetime)
During a battery charge
The batteries are charging (≥90% of charge
reached)
Fast Blinking
Green
After the power up phase
The receiver is locked on the select frequency, the
batteries charge is very low (
<12% lifetime)
Green / Red
blinking
During a scan operation The device is doing a scan of the frequencies
Blue During a battery charge
The batteries are charging (<90% of complete
charge)
“Pink” In the boot mode The device is in the boot mode
RF Led Indicators (Firmware rel. v1.5)
COLOR RF level TONE SQUELCH (19KHz) AUDIO Why is audio disable?
Red
RF>Squelch Enable but not detected Disable Tone squelch not detected
RF<Squelch Enable but not detected Disable Tone squelch not detected
RF<Squelch Disable Disable RF<Squelch
Green
RF>Squelch Enable and detected Enable
RF<Squelch Enable and detected Disable RF<Squelch
RF>Squelch Disable Enable
“Orange” The device is in the boot mode
* to put the MPR30-IFB in boot mode: power on the device push and keep both UP and DOWN buttons for few
seconds (until the led indicators light up, then release the buttons)