WISKA SW 200, Руководство по эксплуатации

Страница: 10 / 16

30101271000_SW200-SW200A Rev 24022012E Operation
10
5. Operation
-
Only use the control knob provided for setting up the searchlight. Never touch the
searchlight casing during operation since there is a
risk of getting burned!
- Make sure that nobody is in front of the searchlight when switching on or during
operation, -
Risk of glare!
-
The searchlight is switched on via a separately installed switch. Switch S1 for
switching on the searchlight, as described in 5.2, is found on the RCU only if a
pan/tilt unit with a control unit exists. If no electromechanical movement unit exists,
switch S2 and the control lever are also absent.
-
Now read on from item 5.2 Switching on.
5.1 Operation with pan/tilt unit via RCU (optional)
The operation of the searchlight with the pan/tilt unit and associated RCU controller
is shown below.
1 Drive indicator lamp
S2 Drive on/off switch
2 Drive control lever
S1 Searchlight on/off switch
3 Searchlight indicator lamp
5.2 Switching on
Risk of getting burned! Never touch the searchlight during operation without
protection. The casing can reach 140 °C. In case of burns cool the injured area
immediately and seek medical help.
Risk of glare! Never look into the light source during operation. This is dangerous for
the eyes. Never point the searchlight directly at anyone. Before switching on make
sure that nobody is near the searchlight.
1. Turn switch S1 on. The lamp should light up immediately.
2. If the lamp does not light up, please refer to chapter 7.3 Lamp replacement and
replace the lamp.
3. If a pan/tilt unit is fitted, switch this on as well with switch S2 on the RCU controller. The
movement unit is now also ready for use and can be moved with the control lever.