14
LIGHTING YOUR STOVE WITH A HEAT GUN
You will need a 120 volt industrial heat gun available at most hardware stores.
DO NOT USE CHEMICALS OR FLUIDS TO START THE FIRE.
1.
Follow steps 1-6 of the lighting with a handheld propane torch instruction.
2.
A heat gun primary burn chamber end slide is available.
3.
Install the heat gun primary burn chamber end slide.
4.
Plug in and turn on heat gun to the high setting then insert heat gun into the primary
burn tube end slide.
5.
Let heat gun run for 30 seconds.
6.
Open the pellet feed door.
7.
Ignition of the pellets will take approximately one minute. When the pellets ignite you
will hear a “whoosh”.
8.
Immediately turn heat gun down to the low setting and continue to run until the stove
reaches 400 degrees. This will happen rapidly after ignition of the pellets.
9.
Remove, turn off and store your heat gun.
10.
You may continue running your stove with the heat gun primary burn chamber end
slide for an open burn or replace with the primary burn chamber slide cover.
