Wisdom SC-2, Руководство пользователя

Страница: 12 / 23

12
preferred listening positions is all that is necessary. But the SC-2 provides storage of
up to four complete and independent calibrations to address various situations.
These four LEDs indicate which of the four setup memories is currently active. They
also serve to indicate that the unit is powered up and operating normally. (When
the unit is in standby, only the amber standby LED on the left side of the front panel
is lit; the blue memory LEDs are off.)
The LEDs indicate which of the four-setup memories is active:
•
LED 1 on = Setup memory #1 enabled
•
LED 2 on = Setup memory #2 enabled
•
LED 3 on = Setup memory #3 enabled
•
LED 4 on = Setup memory #4 enabled
•
LED 1 blinking slowly = Dirac ®
bypassed temporarily
The bypass mode is available so you can hear the difference room correction has
made on your system. When the room correction is bypassed, the active crossover
and other system-specific circuitry are still engaged. This allows you to easily hear
only what the room correction software is doing for your system. You can cycle
through the available memories and back to bypass mode by pressing the Setup
Calibration Switch to the right of these indicators. (See 3, below.)
3. Setup Calibration Selector Switch
Pressing the right side of the center section of the SC-2 front panel will activate a
micro switch that cycles the unit through the available setup memories.
If only one memory has been set up (which is fairly typical), pressing this button
will toggle Dirac on and off. If multiple setups have been stored, pressing this
button will cycle through the available setups in order, ending in the same bypass
mode for the room correction prior to starting the cycle over again:
•
Setup Memory 1
•
Setup Memory 2 (if available)
•
Setup Memory 3 (if available)
•
Setup Memory 4 (if available)
•
Bypass Dirac
®
Rear Panel