Wisdom Sage L100m, Руководство пользователя

Страница: 9 / 16

SAGE L100m WISDOMAUDIO.COM 9
toggle bar secures itself against the opposite side of the drywall ( inside
the wall). Repeat for each anchor location.
5. Install screws suitable for the specific wall material (e.g., sheetrock, brick,
concrete, etc.) in all the remaining holes in the mounting bracket to ensure
secure attachment to wall and avoid any resonance from mounting bracket.
Snug down the center screw as well.
6. Using assistance, while holding the speaker away from the wall, connect
both high- and low-pass speaker cables to the rear mounted connectors. Pay
close attention to connect the correct wires (high- and low-pass) to their
respective speaker connectors while attending to proper polarity.
7. Fix the speaker into the mounting bracket end clips and press down until
you hear the speaker lock into the mounting bracket clips. When properly in
place, it will snap into position and remain held quite firmly.
8. Install the security set screw in the end cap, snugging down to the mounting
clip with the supplied Allen driver. This setscrew prevents the speaker from
coming loose by eliminating the vertical movement required to free the
speaker from the bracket.
If you need to remove the speaker from the bracket for any reason, first remove the
security screw using the supplied Allen wrench. A sharp upward rap with the base
of one hand or even a non-marring, dead blow hammer will help jar it loose.
(Make sure the speaker itself is being supported by an assistant so it does not come
free from the wall unexpectedly.)
Important! Do not use the L100m as a shelf! While its mounting system is quite
rugged, it is designed to securely support the weight of the speaker itself. Do not
place additional objects on it, and do not climb on it.
Making the L100m Connections
As with any system, you should make changes to the connections only when the
power is turned off to avoid any chance of inadvertently causing a problem (such
as a short-circuit).
Note: The Wisdom Audio L100m is a tri-amplified speaker that requires three sets
of speaker wire to each location rather than the usual two. One pair of connections
is for the planar magnetic module, whereas the woofer module uses two sets of
connections, one each for six of the 12 woofers.