Wisdom Sage L100m, Руководство пользователя

Страница: 8 / 16

SAGE L100m WISDOMAUDIO.COM 8
Mounting the L100m on the Wall
The mounting bracket that mounts to the wall is shipped attached to the back of
the loudspeaker. It is removed by pulling “down” on it relative to the end of the
speaker that will be “up” when installed on the wall. (Note that for horizontal
center channel speakers, this means the bracket is pulled
across the narrow
dimension of the speaker.) It is recommended to place a screw into every open
mounting hole so to avoid the bracket possibility resonating once the speaker is
mounted to the wall.
Please note that this guide assumes the wall surface is flat. If not, shims must be
applied to the rear of the mounting bracket so that the mounting bracket is
uniformly secured to the wall and flat (not distorted). The mounting steps are as
follows:
1. Locate the area with the two sets of high- and low-pass speaker cables
coming out of the wall.
2. The inside face of the bracket assembly has arrows stamped into it
indicating which direction must be “up” when it is mounted on the wall.
Align the center screw hole in the mounting bracket next to the speaker
cables and attach somewhat loosely using a dry-wall screw (or similar),
so you can adjust the bracket for plumb.
3. Using a bubble level to ensure that the mounting bracket is plumb, mark
screw holes for EZ-Toggle screws in end clips, using the bracket itself as
your template. You can use any opposing (diagonal) set of holes for
mounting of the two EZ-Toggle screws in each end clip.
4. Rotate the bracket out of the way and install two of the supplied EZ-Toggle
screws in each mounting bracket end clip as follows:
a.
Using a #2 Phillips bit in your cordless drill, spin the E-Z Toggle Anchor
into the drywall until the head of the anchor is seated flush and the
arrows on the head of the anchor point up and down. Repeat this
process for each anchor location.
b. To “set” the clamp behind the drywall, place the mounting screw into
the anchor and push or tap firmly until approximately 1" (2.5 cm) of
screw is protruding (do not rotate). Then remove the screw. Repeat for
each anchor location.
c. Rotate the mounting bracket back over the E-Z Toggles, insert the screw
and continue to turn until fastened tightly. The screw stops when the