Wisdom Sage L100i, Руководство пользователя

Страница: 10 / 28

10
tain that there are no studs, plumbing or electrical conduit in the
intended area behind the wall before you begin marking and cut-
ting!
2. Trace the outer perimeter of the cutout guide with a pencil or a
utility knife.
3. Remove the traced section of the wall using a keyhole saw, and
clear debris from the edge of the hole.
4. Push any insulation to the side.
5. Disassemble bezel/Uni-Grip™ and place the supplied Allen head
screws to the side. Place the bezel in the wall cutout and insert
the Uni-Grip clamping bar through the opening at an angle, work-
ing on one side first. Reinstall the Allen head screws with the
supplied 3/32” drill bit, securing both pieces to each other (sand-
wiching the wall between them), but do not tighten yet. Repeat on
the other side.
6. Using a level, adjust assembly in wall cutout to ensure that the
assembly is plumb. Tighten the Allen screws. Do not over torque
or strip these screws. The large clamping area of the Uni-Grip
system does not require unusually high torque on the screws to be
secure.
7. Paint the bezel and grill as necessary, being careful not to plug
up the holes in the grille. Note that the speaker modules are not
mounted in the bezel and grille assembly at this time. They can
be mounted later, after all the paint is dry.
8. Using assistance to hold the speaker modules away from the wall,
connect all three speaker wires (planar magnetic section, plus two
woofer section speaker cables) to the connectors at the ends of
the back boxes, paying attention to assign the correct band-pass
and polarity to their respective speaker connectors.
Important Note: The Wisdom Audio L100i is a biamplified speaker that requires three
sets of speaker wire to each location rather than the usual two. One
pair of connections is for the planar magnetic module, whereas the
woofer module uses two sets of connections, one each for six of
the twelve woofers. The Wisdom Audio SA-1 system amplifier is
designed to provide two identical outputs for the woofer sections of
a given speaker, for a total of 1000 watts of power for the bass.
All connections are made at the bottom end of the enclosures.
9. Insert the speaker/back box assembly into the Uni-Grip frame and
attach using the supplied Allen head screws and 3/32” drill bit.
Do not over torque or strip these screws.