Wisdom Sage C150m, Руководство пользователя

Страница: 10 / 16

SAGE C150m WISDOMAUDIO.COM 10
We recommend using heavy-gauge speaker wire, the gauge will vary dependent on
your speaker run length. Please consult an authorized dealer to determine what
gauge would be best for your application.
For the purposes of this manual, we will assume that you have already connected
the approved DSP Amplifiers/Processor with Active Crossovers and PEQ as per the
instructions found in its manual. As such, you should have signal coming from your
source component(s) to a preamp/processor, and then on to the signal that is split
into low-pass and high-pass sections, with the low-pass section going to one or
more Wisdom Audio SA Series amplifiers, and the high-pass section going to
additional SA Series amplifiers, which will drive the planar magnetic panels.
Connect the outputs of your Wisdom Audio SA-series amplifier to the appropriate
woofer sections, taking care to get both the channel assignments and the polarity
correct. Connect the positive (+) terminals on the SA Series amplifier to the positive
(+) terminals for the woofer on the loudspeaker; likewise, connect the negative (–)
terminals on the amplifier and the speaker, respectively.
Next, connect the outputs of your chosen amplifier for the midrange/treble to the
Sage C150m planar sections in a similar fashion, taking care with all five channel
assignments and polarity.
Care & Maintenance
To remove dust from the front of your C150m, use a feather duster or a lint-free soft
cloth.
Never attempt to clean the drivers themselves.
Caution!
Do not touch the surface of the planar magnetic drivers, under any circumstances.
The thin film has been carefully pre-tensioned at the factory; any subsequent
contact can only damage it.