Wisconsin Engineering COMFORT W3532, Руководство пользователя

Страница: 12 / 27

User manual W3532
- 12 -
Important!
For the protection of electrical installation:
1. prevent the replacement of the polarity!
2. do not activate the self-moving rotary cutter without
the accumulator!
3. do not use starting cables to start the machine!
Termination of work
After termination of the cutting, it is necessary to disconnect
the drive of the cutting mechanism and to lift the cutting
mechanism to the highest possible position. Brake the self-
moving rotary cutter and secure it with the parking brake,
disconnect the engine, put the ignition key to the “0” position.
Before the disconnection of the engine, leave the gas lever for
about 20 seconds in the position for minimum revolutions on
order to prevent back shock.
Important!
Always remove the ignition key when the machine is
unattended.
Fig.11a
Front suspending equipment
Upon request it is possible to deliver the front suspending
equipment (Fig.11a), which by using makes it possible to
connect a rotary sweeping brush, a rotary snow plough or a
plough iron.
The suspending equipment in pos. “
Z”
Fig.11a is
mounted on the self-moving rotary cutter by means of 2 pins,
pos. “
C”
and 4 clips. The actuator of the lifting “
A”
is
mounted on point
“U”
directly on the pin welded onto the
frame by means of the 2 draw bars of hinge “
T”
. The front
suspending equipment includes the hinge of the plough iron
“R”
which is attached by 4 bolts, position “
S”.
The actuator
for the lifting of the front hinge is controlled by the switch
according to Fig.3c, pos.19.
Instead of the front suspending equipment it is
possible to connect to the front part of the self-moving rotary
cutter, bolster “
N”
according to Fig.11b. The bolster is
attached by 4 bolts in points
“X”
.
Fig.11b
Rear suspending equipment – Fig.11c
Using the rear suspending equipment it is possible to connect a
semi-trailer or other hitching tools.
The hitching equipment (1) is mounted on the rear plate of the
machine by means of 4 bolts. Using the pin (2), the eye of the
semi-trailer is connected to the equipment and is secured with
the safety arrester (3).
During the aggregation with the semi-trailer, the blades
must be disconnected in order to prevent the disconnection
of the engine due to the fact that the grass storage bin or
the cover against stones is not connected.
Fig.11c
Cover against stones DKK-572
The cover against stones (1) enables to cut grass using the
cutter without the need of the bag. It directs the stream of
grass and as a safety element it prevents the flying of stones or
other solid pieces.