Winterhalter UC series, Руководство по эксплуатации

Страница: 5 / 48

Safety notes
3
3 Safety notes
Winterhalter Gastronom GmbH assumes no liability or warranty in the event of non- com-
pliance with these safety and operating instructions.
3.1 General safety notes

Read through the safety notes and operating instruction carefully.

Retain the operating instructions for future reference.

Only use the warewasher after you have read and understood the quick guide and the
safety notes.

Allow the Winterhalter Customer Service Department to provide information about the
operation and functioning of the warewasher.

Train the operating personnel appropriately regarding handling the machine refer them to
the safety notes. Repeat the training sessions at regular intervals to prevent accidents.

Do not climb or sit on the opened hinged door.

Operate this machine only when it is in perfect condition.

A damaged or leaking machine may endanger your safety. In the event of defects,
switch off the machine immediately. Switch the machine on again only when the defect
has been remedied. Switch off the on-site mains switch. Only then is the machine with-
out power.

Contact your installer or electrician if the on-site water or electricity supply is the cause
of a malfunction.

If another fault occurs, notify an authorised service technician or your dealer.

Once the work is complete, close the on-site water supply.

Once the work is complete, switch off the on-site mains disconnector.
3.2 Electrical safety

The electrical safety of this machine is guaranteed only if it is connected to a correctly
installed protective circuit and a residual current circuit breaker. It is crucial that this
basic safety requirements are tested and, in case of doubt, that the on-site installation is
checked by a qualified electrician.
Winterhalter cannot be held responsible for damage caused by a missing or broken pro-
tective conductor (e.g. electrical shock).

Do not open any machine covers or machine parts if doing so requires tools. There is a
risk of electric shock.

For your safety, test the on-site residual current circuit breaker (FI) regularly by pressing
the test button.
3.3 Maintenance and repair work

Maintenance work and repairs may only be carried out by authorised Winterhalter ser-
vice technicians. Improper maintenance or repairs may cause significant danger to the
user, for which Winterhalter is not liable.

When carrying out installation and maintenance work, unplug the machine from the
mains supply. Electrical elements of the machine contain voltage until disconnector from
the mains supply.

Only original Winterhalter spare parts may be used for maintenance and repairs. If orig-
inal spare parts are not used, the warranty is invalidated.

If the mains cable of this machine is damaged, it must be replaced by Winterhalter or its
Customer Service or another qualified person in order to prevent hazards. The mains
cable must be an H07 RN-F type or equivalent.