Charge/Discharge CMOS (JP1)
=====================
CMOS Charge/Discharge CMOS is used to Charge and Discharge CMOS. If you
discharge the CMOS all datas in the CMOS will be erase. To discharge CMOS,
place a jumper cap in pin 1 & 2 then turn on the Power supply for 1 to 2
seconds then turn off the power supply. In this procedure the CMOS is
discharge, all the datas in the CMOS is erase.Place the jumper cap in pin
2 & 3 for CMOS charge, then run setup.
JP1 1-2 DISCHARGE CMOS
JP1 2-3 CHARGE CMOS
Power Supply Connector PL1
==========================
NOTE: Wrong connection will damage the mainboard.
Keyboard Connector J1
=====================
External Battery Connector J2
=============================
(Note of the POLARITY )
NOTE: PIN 1 for (+) PIN 4 for (-)
CRT POWER DOWN JP3
==================
NOTE: This function need a Green function power supply and also note of
polarity. Set power management setup CRT POWER DOWN ENABLE.
SMI LED JP38
============
Keylock/Power LED J9
====================
Turbo LED JP39 (Note of the POLARITY)
=====================================
OPEN NORNAL SPEED LED WILL LIGHT OFF
CLOSE TURBO SPEED LED WILL LIGHT ON
NOTE: If KEYBOARD is used to change the speed TURBO LED will not change.
Turbo Switch JP40
