3
Priority Channel Scanning
Low Battery Warning
There are speech sounds to remind you when battery is
low in English (Battery Low) or Chinese (
請充電
). The
battery needs to be charged immediately.
When battery is near to exhausted, it will remind you
every one second and the power output will lower. By the
time battery is exhausted, radio will turn off it selves.
Please change new battery or battery needs to be
charged.
1.
2.
During programming, assign a channel as "PRI.CH".
Transceiver will scan this channel in priority with others
interchangeably.
Ex: If channel 3 is assigned to be "PRI.CH", scan sequence
will be CH1, CH3(P), CH2, CH3(P), CH3, CH3(P), CH4,
CH3(P), …….. The scanning will continue until channel knob
is rotated (or) scan button is hold on. During scanning, if
busy channel is found, transceiver stops scanning to allow
radio-communication. It will continue scanning after 3
seconds from the end of reception or transmission.
If scanned-out channel is not priority channel, the transceiver
will leave it to priority channel for 3 seconds to channel the
signal and will stay standby on priority channel to check if
there is signal coming in. It will change to back to receiving
channel after 3 seconds from the end of reception or
radio-communication on priority channel. While there is no
signal and if PTT is pushed, transmission is done from
priority channel.
This dealer-programmable function can be activated
by the dealers by selecting PRI CH.