ITX-M-CC452-T10/Configuration
v1.0
www.winsystems.com
Page 14
6.3.3 JP3 - LVDS Configuration Jumpers
NOTE Do NOT install jumpers 1 - 2 and 3 - 4 at the same time.
NOTE Do NOT install jumpers 7 - 8 and 9 - 10 at the same time.
Layout and Pin Reference
6.3.4 JP4 - Board Configuration Jumpers
Layout and Pin Reference
6.3.5 JP5 - Power Mode Jumper
Layout and Pin Reference
Diagram
Selection
Jumper
Position
12V output for backlight
1 - 2
5V output for backlight
3 - 4
eDP Select (installed) / LVDS Select
(removed)
5 - 6
Backlight enable active low
7 - 8
Backlight enable active high
9 - 10
LVDS 6-bit (installed) / 8-bit (removed) 11 - 12
12
2
11
1
Diagram
Selection
Jumper Position
SPI_POWER
Must be installed for normal operation.
Remove if trying to externally program the SPI
on the carrier.
BIOS_DIS_0
Refer to COMe spec for BIOS_DIS options.
BIOS_DIS_1
USB_HOST
Refer to COMe spec.
uSD_SEL
Select uSD support (installed), disabling GPIO
support.
2
1
10
9
Diagram
Selection
Jumper Position
ATX Mode
1 - 2
AT Mode
2 - 3 (default)
3
1
