V. TROUBLE SHOOTING TIPS
POOR WELD
.
1. Check power source for 200 to 240 VAC.(See Fig. #3)
2. Check and/or replace heating element.
3. Gun tip not properly aligned at 2-1/4"-2-1/2'.
4. Additional weight required to compress lap.
5. Incorrect relationship between speed and temperature. Consult membrane manufacturer.
You may be moving too fast for your temperature setting.
NOZZLE COMES OUT OF SEAM
1. Tighten Lock Screw on the frame. (Illustration #23 on the part sheet)
UNIT "JERKING"
1. Check for low voltage on the control box voltmeter.
(See Fig. #3 Should be 210 to 250 VAC )
2. Check drive engage/disengage gear lever.
3. Increase speed setting slightly higher. One revelution of the compression wheel equals
one foot of movement. One revelution in 6 seconds equals 10 feet a minute.
SEAM
1. Too much heat, lower temperature setting.
2.Adjust speed (one revelution of wheel equals to 1 foot)
3. Use least amount of weights. Start with no weights and add-remove weights as required
for best results.
Call
1-630-231-0419
for help or e-mail
-9-
COOL DOWN 10 MINUTES
