Fig. #3
Checking The Control Box Plugs
Each connector is "keyed" or "indexed" for proper alignment when attached.
The drive motor plug
should be securely connected to the lower outlet on the left side of the control
box.
-4-
Drive Motor
connection
Speed Control
Knob
Main Power Input
30A 250V (L6-30)Twist-Lock Plug Furnished
II. OPERATION
A. POSITIONING OF WELDER
(For modified Bitumens APP or SBS)
The pressure roller should be positioned so that it
rolls fully on the surface of the top sheet, about 1/4"
inside the edge of the shelf. The edge of the roller
should not hang over the edge to keep it from
picking up the liquefied asphalt. (See Fig. #4).
THREADING THE HANDLE.
Thread the handle to the back of the welder. Tighten down the locking bolt so that the handle is firmly
bolted to the unit.
Put gear lever to drive to move the welder.
(CAUTION)
- Lifting the welder by the lever can break off the lever.
Fig. #4
Drive Motor
Lever
Main Power
Switch
AC Input
Voltage
Indicator
Handle
COMPRESSION
WHEEL
0.25"
Bleed-Out
