Operating manual
5
8111.01 REV_DA_16052019
1. Assembly Instructions
Please read the instructions carefully before you start assembling! Always mount the dartboard with at least two
adults!
!
1.1.
Wallmounting
Step 1
Open the device and remove the accessory set.
Loosen the safety screw and remove the Wall bracket from
the back of the device.
Step 2
Attach the wall bracket with the supplied
our dowels (Ф 8 mm)
and screws (6 x 50 mm) on the wall. The position of the drill
holes can be found in the sketch beside.
Step 3
ATTENTION:
Please carry out this procedure with
two peoples
– never alone!
Hang the device in the wall bracket and fix the device with the
safety screw on the wall bracket.
Stept 4
After the device has been properly installed, the device can be
connected to the power supply.
ATTENTION:
The power cable must not cause tripping hazards.
Always use appropriate cable extensions, if the distance to the socket
should be too big!
Note: 2 people needed to
mount the device.
