Page: 3
Instruction, Use & Care Manual
Please save this manual for future reference.
Product Name:
LED Solar Motion Sensor Wall Light
SKU #:
WHSL449
Replacing the Batteries
For best results, batteries should be replaced every 12 months.
Detach the housing from the lamp body by pushing it upward.
Remove the screws on the back of the solar wall light.
Remove the old battery. Make sure the new battery is a LiFePO4 3.2V / 500mAh rechargeable battery.
Install the new battery in the battery compartment, ensuring the correct polarity is observed.
Reassemble the unit by reversing the above procedure.
Maintenance
To keep your solar motion sensor light looking new, keep the lens free of dust and deposits by wiping occasionally with a
dry or damp cloth.
Most important, ensure that the solar panel is kept free of dirt and debris at all times. A dirty solar panel will not allow the
batteries to fully charge, and this will shorten the life of the batteries and may cause the light to not function properly.
Technical Specifications
LED Light Setting:
40 Lumen (2 LEDs)
1 Lumen (1 LED)
Rechargeable Battery Type:
LiFePO4 3.2V / 500mAh
Solar Panel:
Amorphous silicon
High Light activation (range):
10-40 seconds
Charge Time (minimum):
6 Hours
Motion Sensor Range:
5 meters (16.4 feet); 90 degrees
