Winpower DE20I4, Инструкция по установке и эксплуатации

Страница: 8 / 28

60708-162
4094-00
6
LUBRICATION
Before starting the engine, check the oil level in the crankcase.
If it is low, refill to the full mark with the proper weight/grade of
oil as recommended by the engine manufacturer’s maintenance
instructions. The necessity of using the correct oil, and keeping
the crankcase full cannot be over emphasized. Failure to use
the proper oil and keep the crankcase properly filled will cause
excessive engine wear and shorten its useful life.
Isuzu oil viscosity table
Use API CC or CD
Fiat oil viscosity table
Use API CF or CH4
COOLANT
Before starting the engine, check the coolant level in the radiator.
If it is low, refill as specified in the engine manufacturer’s
maintenance instructions. The radiator should be filled to about
1 inch below the filler neck. For additional information on engine
coolant requirements see engine manufacturer’s maintenance
instructions.
INSTALLING THE BATTERY
**** CAUTION ****
In the following battery installation procedure, check to be
sure the engine control is in the “stop” position. This should
be your last step before initial start-up.
A customer supplied twelve-volt battery is required to complete
the installation. Installation of the highest CCA rated battery,
within the correct BCI group, will increase cold weather starting
performance.
BATTERY REQUIREMENTS
MINIMUM
Model Voltage BCI Group CCA Rating
DR20I4 12 24 650
DE30I4 12 24 650
DE45F4 12 24 650
DE65F4 12 24 650
DE90F4 12 31 900
DE30 FUEL CONNECTIONS
FUEL INLET
CONNECTION
FUEL RETURN
LINE CONNECTION
FUEL RETURN
LINE CONNECTION
FUEL INLET
CONNECTION
DE20 FUEL CONNECTIONS
42
-35 -30 -25 -20
SAE 10W
SAE 20W
SAE 30
SAE 40
SAE 10W -30
SAE 10W -40
SAE 10W -60
SAE 15W -40 mineral base
SAE 15W -40
semisynthetic base
SAE 20W -60 semisynthetic base
SAE 5W -30 synthetic base
SAE 0W -30 synthetic base
-15 -10 -5 0 5 10 15 20 25 30 35 40 45 50 °C
°F -31 -22 -13 -4 5 14 23 32 41 50 59 68 77 86 95 104 113 122