7-13
SECTION 7 –
PLUMBING
miles to dislodge the solids. A few starts and
stops will aid in the process. Then reconnect the
hose and drain in the normal manner.
NOTE: Always keep sewage drain outlet capped
while sewage connection is not in use.
Holding Tank Level Indicators
See
“Systems Monitor Panel” in
Section 4 -
Appliances
for further information on the
monitor panel and checking tank levels.
See “Specifications” in
Section 1 -
Introduction
for tank capacities for your model.
WASTE WATER SYSTEM
(MODEL 59K)
(Holding Tanks)
The drainage system is self-contained and
uses two separate holding tanks to contain the
waste water until it can be dumped at an
appropriate waste water disposal site. This means
you can use the toilet, sinks, and shower even in
areas where utility hookups are not available.
The black water holding tank contains the
sewage from the toilet and bathroom lavatory.
The gray water holding tank contains the waste
water from the galley sink and shower.
See “Specifications” in
Section 1 -
Introduction
for tank capacities for your model.
Dumping Holding Tanks
(Model 59K)
1. Remove sewage drain hose from storage
compartment (located on left sidewall).
2. Remove dust cap from sewage drain outlet
and connect sewage drain hose. Be sure it is
firmly attached.
3. Place the outlet end of sewage drain hose into
disposal opening.
NOTE: Black and Gray Waste Tank Drain valve
positions may be reversed, depending on
floorplan and tank location.
4. Open the Black Waste Tank Drain valve with
a quick pull and make sure there are no sags in
the hose. Move the hose gently about to
dislodge any waste and ensure complete
drainage. Close Black Waste Tank Drain
valve as soon as tank is empty.
Sewage Drain Hose
(Located on left sidewall)
-Typical View
Sewage Drain Outlet
(Located beneath motorhome)
*Model 59K
