4-11
SECTION 4 –
APPLIANCES AND SYSTEMS
4. After about 30 seconds, the furnace burner
should light.
5. The furnace should now cycle off and on
automatically as the thermostat demands just
like a household furnace.
NOTE: If heat does not come out of the heat
ducts after a minute or so the burner is
not lit.
Turn thermostat off for 3-5 minutes,
check to be sure propane gas tank valve
is open and tank is not empty, then try
steps 2-4 again.
If the furnace will not light after three
attempts, go to Shut Down steps and
contact your dealer or a local RV service
center for repair.
To Shut Down:
1. Move thermostat switch to OFF position.
2. Close propane tank valve if coach will be
stored for a period of time.
Further Information
Please see the furnace operating instructions
provided in your InfoCase for further
information, including operating precautions,
and periodic maintenance. See the Coach
Maintenance Schedule for recommended
intervals.
NOTE: If the furnace burner has any residuals
of metal protectant or lubricants used
during manufacture of the furnace, it
may smoke slightly when the furnace is
used for the first time and may set off
your smoke alarm.
We recommend that you provide
adequate ventilation when using the
furnace for the first time to avoid a
nuisance smoke alarm.
We do not recommend removing the
smoke alarm battery.
ELECTRONIC THERMOSTAT
(Central Heat/Air Conditioning System)
The thermostat, located on the OnePlace
®
panel, controls heating, air conditioning, cooling
fan and heat pump operation.
NOTE: The thermostat does not automatically
switch between heating and cooling. You
must place the thermostat switch in the
desired position.
Heating:
•
Slide the thermostat switch to “Gas Heat”
position.
NOTE: Follow proper furnace lighting
procedures described previously in this
section.
•
Adjust the temperature setpoint to personal
preference if needed. See “Changing
Temperature Setpoints.”
Digital Thermostat Display
The digital display normally shows current
room temperature, with the word “ROOM” in
small letters at the left side of the display. When
you press the temperature selector button up or
down, the display will show the word “SET” and
the new temperature setpoint until you release the
button.
Thermostat (Source) Switch
COOL= Air Conditioning
ELEC = Heat Pump
GAS = Furnace
Temperature Selector
Central Air Thermostat
