Winmate W10IB3S-PCH1AC, Руководство пользователя

Страница: 15 / 53

18
GETTING STARTED
Jumpers
Jumper list
The following table lists the function of each of the board's jumpers.
Label Function Note
JP1 Inverter Voltage Select 3x1 header , pitch 2.0mm
JP2 Inverter Enable Select 3x1 header , pitch 2.0mm
JP4 DC Mode Control 3x1 header , pitch 2.0mm
JP5 From SoC Brightness PWM Voltage Select 3x1 header , pitch 2.0mm
JP6 Brightness Control Select 3x1 header , pitch 2.0mm
JP7 Brightness Control to VRD 3x1 header , pitch 2.0mm
JP8 COM Port Select 2x3 header , pitch 2.0mm
JP9 COM Port Select 3x4 header , pitch 2.0mm
JP10 VRD Brightness Function 3x1 header , pitch 2.0mm
Jumper settings
A metal-bridge jumper used to close an electric circuit, and it usually consists of two metal
pins and one small clip protected by a plastic cover that slides over the pins to connect them.
Users can connect the pins with the clip to close a jumper, and remove the clip to open a
jumper. Generally, a jumper will have three pins which labeled 1, 2, and 3. In this case, you
would connect either pins 1 and 2, or 2 and 3.
The jumper setting diagram is as below. If a jumper shorts pin 1 and pin 2, the setting
diagram is shown as the right one.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have any
doubts about the best hardware configuration for your application, contact your local
distributor or sales representative before you make any changes.
1
2
3