30
SETUP Menu
TV OUT FORMAT
The camera can be connected to a TV by plugging a TV Out cable into
the side of the camera (see section on Accessing Photos and Videos).
This setting controls the signal coming out of the camera’s TV OUT jack.
NTSC –
use this setting if you are using a TV in North America.
PAL –
use this setting if you are using a TV outside of North
America.
FLASH
(WSCA02 only) – The BirdCam 2.0 is equipped with a flash for
nighttime photos.
AUTO –
when the camera’s light sensor determines that there
is not enough light to take a good photo, the flash will be used.
You cannot ‘force’ the flash to fire all of the time (eg - in bright
daylight). Note: when flash is being used, battery life will be
reduced and cycle time between photos will increase. Flash is
not used in VIDEO mode.
OFF –
the camera’s light sensor will put the camera to sleep in
the evening when light decreases, and awaken the camera in
the morning. The flash will not be used.
33131 birdcams_userguide_01_2011.indd 30
12/2/10 9:40 PM
