Winflo 631T, Инструкции по установке, обслуживанию, использованию и гарантии, Страница: 8 / 8

CARE and MAINTENANCE
Do's:
–
Clean your range hood using a non-abrasive cloth or sponge and liquid detergent.
– Always wipe in the direction of the grain pattern.
– After cleaning rinse with water.
– Make sure range hood is dry after cleaning.
Cleaning Method
Use liquid mild-detergent soap and water, do not use hard abrasive cleaners.
Wipe with damp soft cloth or non-abrasive sponge, then rinse with clean water
and wipe dry.
Exterior Surfaces
To avoid damage to the exterior surface, do not use steel wool or soap filled scouring
pads. Always wipe dry to avoid water marks.
IMPORTANT: Clean the hood and panel filters frequently per the following
instructions. Replace the panel filters before operating hood.
Don'ts:
– Do not use steel wool or like products as this will cause scratching and iron
residue that could lead to rusting and corrosion.
– Do not wipe against the grain pattern as this will impact the original finish.
– Do not use chlorine bleach.
Cleaning
Grease/Baffle Filter
– Remove the filter by pulling the spring release handle and then pulling down
the filter.
–
Wash filters as needed in dishwasher or hot detergent solution (low
temperature, short cycle).
– If your model has a grease tray, please remove, drain and clean periodically.
– Make sure filters are completely dry before putting back into range hood.
–
Reinstall the filter by making sure the spring release handles are toward the
front. Insert filter into upper track.
– Push the spring release handle.
– Push up on filter and release handle to latch into place.
Electrical harness connection
Replacing the LED light
– Turn off the range hood and allow the LED light to cool.
–
To avoid damage or decreasing the life of the new bulb, do not touch bulb with
bare fingers. Replace bulb wearing cotton gloves to handle bulb.
– If new LED light does not operate, make sure the lamps are inserted correctly
before calling for support.
–
Replacement lights can be purchased. The light model for your unit will be
listed on a label on the underside of the range hood. If you need assistance
identifying the light model contact us at support@winslyn.com.
To replace:
1. Disconnect the power cord to ensure unit does not turn on.
2. Remove filters.
3. Reach behind the light and push towards you until the light pops out.
4. Disconnect the electrical harness.
5. Attach new bulbs to the electrical harness.
6. Snap bulbs back into unit and replace filters.
7. Reconnect the power cord.
Gre ase tray (If your model contains)
– Periodically remove the grease tray (M) and clean built up grease collection.
17 18
Filters for ductless operation
– Replacement filters can be purchased. The filter model for your unit will be
listed on a label on the underside of the range hood.
– It is recommended to replace the filters every 6 months . If you need assistance
identifying the filter model contact us at support@winslyn.com