J
K
L
Parts not supplied
†
Duct tape
†
Preinstalled ventilation system and ductwork
†
Preinstalled outside duct cap or weatherproofing
7
E
D
F
C
H
G
I
M
8
Installing the range hood
This installation is for mounting the product to a wall. Ensure your wall
has the proper support to hold the range hood weight. These instructions
are general guidelines, please consult your installation specialist regarding
the best type of mounting hardware and support system based on your
wall construction. All wall mounted range hoods, if possible, should be
installed and supported by studs behind the wall (hardware not included).
In the event studs are not in alignment with the wall mount mounting plate
holes, a wooden cross support system may need to be retrofitted to your
existing studs. All homes are different and installations will vary.
1. Begin installation by removing the filters (G) and removing any tape on the air
flow flappers (C).
2. Remove protective film from range hood and ducting. When handling the
ducting please wear protective gloves to avoid sharp edges.
3. If your model has an electronic touch sensor control panel, remove the protective
plastic film covering the control panel.
4. Insert the rubber bumpers (L) by attaching to the back of range hood at the
two outside locations. For some models, you will need to remove the two
outside screws, place bumper over hole and reattach the screw. See below.
Some models have the bumper already attached.
5. S ome models, due to packaging needs, may come with the mounting brackets
attached to the back of the range hood inverted and attached with screws (see
below).
1) Unscrew and reverse mounting brackets
2) Screw in mounting brackets, as shown below, using screws removed in step 1
B
A