VERSION 3
04/01/2021
I
NSTALLATION AND
U
SAGE
G
UIDE
WINESP40CAPRO
Page 21
7 (N)
–
Blue
Numbered wires
Power
Outdoor unit
Indoor unit
3.7
INSTALLING THE CONDENSATE DRAIN
The drain hose must not be stuck or form an upward loop!
The recovery container could overflow if the hose is not turned downward.
4
STARTING UP THE WINEMASTER
®
AIR CONDITIONER
The thermostat displays the air temperature inside the air-conditioned room within a range of 2°C. The
thermostat is factory set for a setting of 12°C. When the air conditioner is started up, check and modify that
temperature if required using procedure (4.2.1, p21).
4.1
Connecting the air conditioner
When you start the air conditioner, the room temperature is displayed:
-
If the temperature is above the thermostat setting, the air conditioner starts up after a two-minute
delay.
-
If the temperature is below the thermostat setting, the compressor does not start up. Only the fan of
the indoor unit operates.
4.2
Starting up
4.2.1
TEMPERATURE SETTING
The temperature is set on the thermostat:
-
Press the button
for one second till the set temperature flashes.
-
Use the button
to increase the temperature setting.
-
Use the button
to decrease the temperature setting.
-
Condensation water is removed through a
hose that is delivered with the device
-
Fasten the hose to the outlet pipe (1) with the
clamp (2) supplied with the device
-
The water flows by gravity and must be
connected to a waste water drain or into a
bucket that must be emptied regularly
