MOUNTING THE ANTENNA, OPTION 1
MOUNTING THE ANTENNA, OPTION 1
4
STEP 1. Place the circular gasket
on the attachment tube.
STEP 2. Route coaxial cable from the location of the
power supply to the location of the antenna.
STEP 3. Connect the
coaxial cable (coming up
through the base) with
the mini-coaxial cable
running down from the
antenna head.
STEP 4. Mount the pedestal for the antenna. Check with
the vehicle manufacturer for any screw requirements
and for approved sealant for your boat. Apply a liberal
amount of sealant around the base of the
antenna and over screw heads.
STEP 5. Carefully pull the cable slack downward
through the pedestal assembly.
IMPORTANT!
STEP 6. Align the guide mark on the antenna head with
the same groove on the attachment tube.
STEP 7. Push the antenna head down until the head
locks into place.
WARNING! Once the antenna head and pedestal
are connected, the head cannot be removed without
incurring damage.
STEP 8. Lightly pull the antenna head upward. If the
head does not slide up on the pedestal, the head is fully
seated. If the head slides upward, repeat steps 5 to 8
and connect the head to the pedestal.
DO NOT PROCEED until the head is fully seated.
Then, continue with Installing the Power Supply.