RP-SK05 DIRECTV
®
SLIMLINE LNB REPLACEMENT
1. Remove and set aside the four nuts and
bolts holding the LNB guard to the feed
arm. Then, slide the LNB guard down the
feed arm and toward the reflector.
2. Remove and set aside the two screws
holding the LNB to the feed arm.
3. Carefully slide the LNB out from the feed
arm. Disconnect the four coax cables from
the LNB using a
7
/
16
” wrench.
4. Connect the four coax cables running
through the feed arm to the replacement
LNB. The coax cables can be connected in any order. Tighten the cables until
fingertight, and then use a
7
/
16
” wrench to tighten a quarter turn more.
5. Slide the LNB into the feed arm, and re-install the two screws (removed earlier)
through the underside of the feed arm and replacement LNB. Tighten.
6. Slide the LNB guard up the feed arm and over the LNB. The front of the LNB
guard should be ~½” in front of the LNB and should not be touching the LNB.
Install the four bolts through the four holes in the LNB guard. Thread a nut onto
each bolt, and tighten.
RP-SK09 DIRECTV
®
SWM SLIMLINE
LNB REPLACEMENT
1. Remove and set aside the four nuts
and bolts holding the LNB guard to
the feed arm. Then, slide the LNB
guard down the feed arm and toward
the reflector.
2. Remove and set aside the two screws holding
the LNB to the feed arm.
3. Carefully slide the LNB out from the feed arm.
Disconnect the coax cable from the LNB using
a
7
/
16
” wrench.
4. Connect the coax cable running through the feed arm to the replacement LNB.
Tighten the cable until fingertight, and then use a
7
/
16
” wrench to tighten a
quarter turn more.
5. Slide the LNB into the feed arm, and re-install the two screws (removed earlier)
through the underside of the feed arm and replacement LNB. Tighten.
Screws holding
LNB to feed arm
Bolts holding
LNB guard
to feed arm
LNB guard
Bolts holding
LNB guard
to feed arm
Feed arm
Screws holding
LNB to feed arm
Front of
LNB guard