4
5
Attaching the Antenna with reflector to the Base
1. Route the 6’ mini coax cable through the base, and screw it securely to
the antenna.
2. Slide the antenna with reflector onto the base.
3. Using a screwdriver, slightly tighten the two screws, to secure the antenna
to the base. (See Fig. 7.)
Attaching the Reflector to the Antenna
1. Starting from the right side, slide the clip attached to the reflector diagonally
into the notch at the back of the antenna. (See Fig. 4, 5.)
2. Once the clip is pushed in, slide it to the side so that it forms a 90 degree
angle to the antenna’s edge. (See Fig. 6.)
3. Repeat steps 1 and 2 for all four clips.
Fig. 6
Fig. 4
Fig. 7
Fig. 5
Making Connections
1. Connect the mini coax cable attached to the antenna to the connection on
the power injector labeled “Antenna”.
2. Connect the 2’ coax cable from the connection on the power injector
labeled “TV” to your HDTV or set-up box.
3. Connect the 6’ standard coax cable from the connection on the power
injector labeled “Power” to the AC adapter.
4. Plug in the AC adapter to a standard AC outlet.
Attaching Rubber Feet to the Base
Remove the protective adhesive
strip from the four rubber feet and
apply them to the bottom of the
antenna base.
Fig. 9
Feet
Fig. 8
AC Adaptor
(Supplied)
6’ Standard
Coax Cable
(Supplied)
LED
Power IN
ANT.
Power
Injector
TV
Coax Cable to Digital
TV, Digital Converter
Box, Distribution Amp
or Splitter
6’ Mini Coax Downlead From Antenna
Installation
Installation
