Winegard RC-1010, Руководство по установке

Страница: 19 / 36

19
Memorize Channel Manually
If the “Auto-Scan” feature does not scan in all
desired channels, you may be able to manually add
the channel. You may need to re-orient your
antenna to find the signal.
● On the Channel menu page, select the third item
“Manual Scan”.
● Press ENTER, then press numeric buttons to input
the channel number. You must enter the digital
channel carrier. Refer to antennaweb.org to
determine digital channels in your area. Press
ENTER
● Press the ENTER button when the message “Add
channel” has shown.
●● If the ATSC signal is found and locked, the Status
will show message “Add No.XX 8VSB channel
successfully” , then you can press EXIT or MENU
to leave the menu page and watch the program,
or go ahead scanning other channels.
● If the signal is not locked, the status will show
“No Channel No. XX”. You can scan the signal
again or refer to the signal level bar “Signal” for
aligning the direction of the antenna to get the
signal.
● When the signal is locked and the receiver is
on the channel, you can enter this page to check
the signal level.
Note : It’s suggested that you to contact the
antenna Installer when you have to trouble of
locking the signal.
● Press the EXIT button to go back to the main
menu or press the MENU button to leave.