Winegard Rayzar Air Replacement Antenna Head
Parts
Choosing your Installation Method
The Rayzar Air replacement antenna head is versatile
and can be installed in a variety of ways. The Rayzar
Air replacement head comes with a 16
″
boom but
can be installed using the included boom or using the
existing boom from the existing antenna. If replacing
a Rayzar Air antenna with another Rayzar Air antenna,
follow the instructions for installing the antenna head
with the included boom. If replacing a Sensar antenna
with the Rayzar Air antenna, determine whether you
would prefer to install the antenna using the included
(16
″)
or existing boom.
Winegard recommends installing the replacement
antenna head with the included boom.
If wanting to replace the existing antenna using the
included (16
″)
boom, proceed to “Replacing an Existing
Antenna using the Included Boom” on this page.
If wanting to replace the existing antenna using the
existing boom, proceed to “Replacing an Existing
Antenna using the Existing Boom” on page 2.
Replacing an Existing Antenna
using the Included Boom
Recommended Installation
Before proceeding, make sure that the power supply is
turned off and the antenna is in the stowed position.
Align the holes in the Rayzar Air 16” boom and boom
adapter. The slot in the boom and the “W” logo on the
antenna head should be facing the same direction.
Place a washer on two ¼” x 20 bolts, and insert the
bolts through the aligned holes in the boom and boom
adapter.
Place a washer on the end of each ¼” x 20 bolt, and
thread a nut onto each bolt. Tighten nut until the boom
adapter touches the boom on both sides.
WARNING: Do not overtighten bolts.
Disconnect the coax cable from the existing
antenna head.
If replacing a Sensar antenna with the Rayzar Air
antenna, cut the coax connector off of the coax cable.
Pull the coax cable out of the boom.
Antenna
Head
Boom
Adapter
F-jack
Boom (16
″
)
¼
″
x 20 Bolt (2)
Washer (4)
Nut (2)
“W” Logo
Slot in Boom
1.
2.
3.
5.
Page 1
4.
!