Assembly GUIDE
or visit
wineracksamerica.com
Questions?
888.373.6057
Standard Tasting Table
Page 3
3
FRONT OF RACK
For no visible hardware, add wood glue to the inside of each connector notch. Place the connnector on your
rack and carefully press each notch into place. Hold until glue is dry. (figure A)
For minimal visible hardware, add wood glue to the inside of each connector notch. Place the connector
on your rack and carefully press each notch into place. Hold until glue is dry. For added support, use a finish
nailer to attach the connector to the two end ladders and one middle ladder. (figure B)
For a professional installation, secure the connectors using a finish nail gun to drive a nail through the connector
into each vertical ladder. If you do not have a finish nail gun, drive one of the provided finish nails into each
vertical ladder until it is flush. Then, countersink the nail using a nail setter until the head of the nail is about
1/16" below the surface of the wood. (figure C)
A
B
C
A
B
C
+
++
or
4.
Flip rack over. Attach a screwless 8 column connector to the top and bottom of your rack. Make sure the rack is flat
on the floor while attaching screwless connectors. (figure 3)
Standard Tasting Table kits are designed to show no visible hardware on the front of the rack. Use of of these following
methods to install the screwless connectors:
