MACHINE OPERATION
SABER (QSC) 980067 11/13/02
3-12
EMPTYING AND CLEANING TANKS
1.
Park the machine next to a floor drain. Drain
hoses are on the rear of the machine.
2.
Turn the machine power off.
SOLUTION TANK
1.
Unhook the small drain hose from the retainer.
Unscrew the T-handle plug enough to loosen
it, then lower the hose in the direction of the
drain. Slowly remove the plug from drain
hose.
2.
Remove the solution tank cover.
3.
Flush the solution tank out with clean water
and run several gallons of clean water through
systems. Do not use water hotter than 140°F
(60°C) to clean the tank, damage may occur.
NOTE: Never allow solution to remain in tank.
Damage to tank, seals and valves could occur.
4.
Replace the drain plug and secure the drain
hose in the bracket.
RECOVERY TANK
1.
Unhook the large drain hose from the retainer.
Unscrew the T-handle on the plug enough to
loosen it, then lower the hose in the direction
of the drain. Do not stand in front of the end
the of hose. Recovered solution will come out
with force. Slowly remove the plug from the
drain hose.
2.
Raise the solution tank to access the recovery
tank. Make sure the support arm is fully
engaged. Remove the vacuum motor and rear
access cover. Flush the recovery tank out with
clean water. Do not use water hotter than
140°F (60°C) to clean the tank, damage may
occur.
3.
Clean off the float and check for free
movement of the float ball. The float is
attached to the bottom of the vacuum motor.
4.
Replace
the drain plug and secure the drain
hose in the bracket.
5.
If the machine is to be stored, leave solution
tank in the raised position
.
