Windsor 1.009-082.0, Руководство по эксплуатации

Страница: 13 / 35

HANDLE INSTALLATION
86373120 FLOOR POLISHER
3-2
The handle must be installed by qualified personnel. Read all instructions
thoroughly. The machine is shipped with handle unassembled.
La poignée doit être installée par du personnel qualifié. Lisez toutes
les instructions attentivement. La machine est livrée avec la poignée
démontée.
The machine is shipped with handle unassembled.
Follow these steps for installation:
1. Remove handle and deck assembly from carton.
2. Attach handle assembly to base using hardware kit
(86219680) (attached to handle in a plastic bag) items
1, 2, and 3.
NOTE: The spacers (items 1) are required for the correct operation of the handle. The spacers are
positioned completely inside the pivot holes in the casting, and are held in place by tightening the
bolts and washers (items 2 and 3) against the spacer.
3. Remove bolt, nut and washers (items 4, 5 and 6) from lower block on handle assembly. Attach links as
shown. Tighten bolt and nut securely, then back off 1/4 to 1/2 turn.
4. Check handle for movement up and down.
5. Plug motor cord into handle cord receptacle.
(SEE NOTE)
HOLE
PIVOT
ASSEMBLY
DECK
PLUG
MOTOR
RECEPTACLE
6
MOTOR PLUG
4
5
1
2
3
THE CORD ASM AND CORD HOOK.
ASSEMBLY, CHECK ORIENTATION OF
WHEN INSTALLING THE HANDLE