Installation of Brackets – Inside Fit
• Measure 55mm at the cordlock side, each jam for end
bracket location and make a mark for each
• If you are given more than two installation brackets with
your order, space the additional brackets evenly between
the two end brackets.
• Centre each bracket on the marks you have made and then
mark where the screw holes need to be made.
• Check the surface where you will be mounting the brackets
to ensure it is level and the brackets are aligned.
• Drill the screw holes. NOTE: installation may require wall
anchors. (These are not provided)
• Fasten the brackets to the mounting surface by using the
screws provided.
To adjust the drop height and level the bottom rail:
• Loosen the cord on the ferrule
• Slide the ferrule up or down until the bottom rail is at the ordered drop height
• Tighten the cord on the ferrules
• Push the ferrules into the pockets non handleson there
• Again check the drop height and level. Adjust if necessary
CAUTION:
Do NOT trim the excess cord under the ferrules. The installer will trim them after
making fi nal adjustments during installation.
Installation of Brackets – Outside Fit
• Centre the head rail over the window opening at the height you wish. Lightly mark each end
of the head rail using pencil.
• Measure and mark 8cm in from both ends of the head rail.
• If you are given more than two installation brackets with your order space the additional
brackets evenly between the two end brackets.
• Centre each bracket on the marks you have made and then mark where the screw holes need
to be made. NOTE: The rear of the brackets must be fl ush against a fl at mounting surface -
DO NOT mount brackets to a curved surface.
• Drill the screw holes. NOTE: installation may require wall anchors. (These are not provided)
• Fasten the brackets to the mounting surface by using the head screw provided.
HONEYCOMB
Installation Operation Care 2015
Re-order 9699
Care and Cleaning
Honeycomb blinds are anti-static, dust resistant fabric.
For most honeycomb fabrics, the following options are available if your blind needs cleaning:
Please take care with the Blockout as the metallic coating inside is very delicate.
Dusting
Regular light dusting with a feather duster is all that is needed in most
cases.
Vacuuming
For deeper cleaning, vacuum gently with a brush attachment.
Spot Cleaning
Prepare a solution of warm water mixed with a mild detergent.
Dampen a clean cloth in the solution and wring it out well.
Dab the spot you want to clean with the dampened cloth until it is gone.
DO NOT rub the fabric.
Allow the blind to dry in the fully lowered position
Removal of Blind for cleaning
• Fully raise the blind.
• Unscrew the tab screw on each bracket to release
the head rail taking care not to fully unscrew it to
make replacement easier.
Before you install into brackets, release the cord lock by about 30 mm so that it is easier to
clip the blind into the back of the bracket. You should hear an audible click. You then need
to shift the fabric out of the way of the back of the headrail so you can tighten the screw up.
