17
10.4
Power supply card
– WCA 3P6
Mains and protective earth is connected
to the MotorController via the power
supply card.
On the standard version of the
MotorController the power supply card
enables connection of weather station or
other sensor.
S4 X1
Connection to mains.
S4 X2
Connection to e.g. weather station. See ”S3 X9” under ”Input car – WCA 3KI” for description of connetion of wind
/ rain sensor.
S4 X3
Connection to power supply WCA 3P3 (10A), or WCA 3P5 (20A)
Protective earth (PE).
11
Configuration of the MotorController
The MotorController
is configured by pressing the two keys ”↑” and ”↓” on the input card, at the same time for 10 seconds.
The MotorController must be configured
-
After re-installation, changes, or change of actuators
-
When / if MotorLink
®
actuators are connected
-
If the cables have been moved
-
When components are removed from the MotorController
Note, during reconfiguration actuator outputs can be activated in both directions.
If the yellow diode on the motor line card blinks after a configuration, an error has occurred in the configuration, see chaptor
“Fault
detection via LED” for identification of errors.
Actuators are to be connected on the motor lines. ±24V standard actuators and actuators with MotorLink
®
can be connected to
all motor lines, but a motor line can only be connected to one type of actuators
– either ±24V standard or MotorLink
®
actuators.
The MotorController will automatically detect the type of actuator, which is connected to the MotorController.
12
Fault detection via LED
12.1
Fault detection on the MotorController
In case of error on the MotorController, the yellow diode on the motor line card will blink and via blink sequence indicate an error
message. Depending on the type of error message will consist of 2 or 3 blink sequences, separated by a seconds pause. The first
blink in an error message has a duration of one second, and thereby indicating when the error message (1
st
blink sequence)
begins. The remaining blinks of the error message has a duration of 0.5 seconds. The error message is repeated until the error has
been rectified. Between 2 error messages there is a pause of 2 sec.
