MODEL CER163M
5
4
Pre-Operating Instructions
1. Carefully remove the heater from the box (PLEASE SAVE THE CARTON
FOR OFF-SEASON STORAGE).
2. Make sure the unit is in the OFF position before plugging the heater
into a polarized 120V AC, 60 cycle outlet. (Please use caution to avoid
overloading your circuit by NOT using other high wattage appliances in
the same outlet.)
3. Place the heater on a firm level surface.
Operating Instructions
Control Panel Functions (Fig.1)
Fan/Heat Dial:
To operate turn Thermostat Dial clockwise to the maximum setting, then turn the
Fan/Heat Dial to the desired setting.
OFF
FAN ( ):
Cool air only
LOW HEAT (LO):
1000 watts of heat
HIGH HEAT (HI):
1500 watts of heat
CAUTION:
FRONT GRILL IS HOT WHEN UNIT IS IN OPERATION.
Thermostat Dial
1. Set the thermostat to the highest setting by turning the dial clockwise
until it stops.
2. Turn the Fan/Heat Dial clockwise to
(LO)
or
(HI)
setting.
3. When the desired temperature comfort level is reached, lower the thermostat
setting until the fan/heater stops operating. This is done by moving the
thermostat control counter-clockwise toward the
(FW)
setting.
4. The thermostat will now automatically maintain the pre-set temperature level
by turning the heater on and off.
Note:
Unit comes with an ANTI FROST function, that if a temperature of 40°F /
4°C is reached the unit will turn on..
Note:
It is normal for the heater to cycle on and off as it maintains
the preset temperature. To prevent the unit from cycling, change the
thermostat setting.
Manual Oscillation:
Hold the base, then twist from the handle either
left or right.
Red Power-On Indicator Light: (Fig. 2)
Illuminates when heater is on.
OPERATING INSTRUCTIONS
Fig. 1 Control Panel Functions
Thermostat
Dial
Overheat Protection Shut-Off
When an overheat temperature is reached, the system will automatically shut
the heater off. It can only resume operation when the user resets the unit.
To reset the heater:
1. Turn the Fan/Heat Dial to the (OFF) setting.
2. Unplug the heater.
3. Check to make sure there are no objects obstructing
the airflow around the heater
4. After 5-10 minutes, plug the unit in again and operate normally.
Safety Tip-Over Switch
This heater is designed to automatically shut-off when tipped forward or
backward. When returned to its normal upright position, the heater will
automatically turn on again.
Fig. 2 Indicator Lights
Red Power-On Indicator Light
Fan/Heat Dial
HI
LO
FW
OFF
HOT
