Wind WD25TC-IN, Руководство по эксплуатации

Страница: 4 / 36

Parts and Functions
Indoor Unit
Remote controller
1 6
5. LOCK display
1
Inlet 4 Air Purifying Filter
2
(inside)
7
3
4
2
Inlet grille
3 3
Outlet
5
Anion generator
(inside)
8
5
8
Supplemented
Operation mode
QUIET SLEEP electrical HEALTH TURBO
heating
Emergency
Remote controller
Switch
15
17
6 Vertical blade
13
FAN TIMER
14
(adjust left and
7
Horizontal flap
(adjust up and down air flow
right air flow)
Display board
CONFIRM 12
SMART
CANCEL
20
Don't adjust it manually)
10
COOL HEAT DRY 11
16
EXTRA
21
SLEEP
FUNCTION
SWING
18
19
9
TURBO/QUIET
1. Mode display
10
℃
heating--- A-B yard---
air sending----horizontal
swing
Operation mode
SMART COOL DRY
FAN
HEAT
Remote controller
20. CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
21. SLEEP button
Display
circulated
LO MED HI AUTO
Loading of the battery
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Outdoor Unit
3
Be sure that the loading
is in line with the " + "/"-";
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change- over
type fluorescent lamp or wireless telephone is installed in the
room, the receiver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batteries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
remove the batteries and reload several minutes later.
4
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
Please be subject to the actual produce purchased the
above picture is just from your reference
Hint:
Remove the batteries in case won't be in use for a long period.
1
6. TIMER OFF display
TIMER ON display
7. TEMP display
8. Additional functions display
9. TURBO/QUIET button
10. HEAT button
11. COOL button
12. SMART button
13. FAN SPEED button
14. TIMER button
15. POWER ON/OFF button
16. DRY button
17. TEMP/HOUR button
18. SWING button
19. EXTRA FUNCTION button
Function:
Health--- Healthy airflow position1
--- Healthy airflow position 2---
standard position ---
℉
/
℃
transform---
2. Signal sending display
3. SWING display
4. FAN SPEED display
Display board
1
Signal receiver
1
2
2 Setting temp.display