CAUTION:
Before installing, remove any protective film from all parts.
The custom hood liner must be installed before the insert unit. For installation into shallow cabinets
(20-
1/2
” to 21-
1/2
“ inside depth)
the insert must be installed before the liner front panel section.
This must be done because the insert flange must fit under the liner front panel section when an
overlap occurs.
Refer to UIX2916S and UIX3816S instructions for mounting height details.
C
B
A
A
B
D
1
2
A
Install 1 small pad (
A
), included in the
hardware package, to each side of the main
liner plate. (See figures 1 and 2)
Temporarily install the main liner plate (
B
) to
the external base of the custom hood (
C
).
When inserting the main liner plate, push
slightly on the pads (
A
) to prevent damage.
Main liner plate should be positioned as far
back as possible.
Using a pen, mark the outline of the future
opening for the power pack. Remove the
main liner plate (
B
) from the custom hood.
Cut out an opening in the bottom of the
custom hood.
Reinstall the main liner plate to the base of
the custom hood and secure it with (5) 3/4”
screws.
Slide the front panel section (
D
) into the nose
of the custom hood base. Take care not to
scratch the main liner plate when installing
the front panel section of the liner. Assemble
it to the cabinet using (3) 1/2” screws.
Note: When installing the insert it will need to be secured to a wood surface and not only to
the liner. See insert installation manual for more detailed mounting instructions.
www.windcrestcnp.com
2
3
4
6
5
UL29xxS and UL38xxS Liners
Installation - Stainless Steel Liner
