Wind Crest UIX3622S, Инструкция по использованию, уходу и установке

Страница: 16 / 22

14
www.windcrestcnp.com
FCC Caution:
7RDVVXUHFRQWLQXHGFRPSOLDQFHDQ\FKDQJHVRUPRGL¿FDWLRQVQRWH[SUHVVO\DSSURYHGE\WKHSDUW\UHVSRQVLEOHIRU
FRPSOLDQFHFRXOGYRLGWKHXVHU¶VDXWKRULW\WRRSHUDWHWKLVHTXLSPHQW([DPSOHXVHRQO\VKLHOGHGLQWHUIDFHFDEOHVZKHQFRQQHFWLQJWR
FRPSXWHURUSHULSKHUDOGHYLFH7KLVGHYLFHFRPSOLHVZLWK3DUWRIWKH)&&5XOHV2SHUDWLRQLVVXEMHFWWRWKHIROORZLQJWZRFRQGLWLRQV
7KLVGHYLFHPD\QRWFDXVHKDUPIXOLQWHUIHUHQFHDQG7KLVGHYLFHPXVWDFFHSWDQ\LQWHUIHUHQFHUHFHLYHGLQFOXGLQJLQWHUIHUHQFHWKDWPD\
cause undesired operation. This remote control may operate in humid environments, but not when placed on a wet surface.
REMOTE CONTROL MAINTENANCE:
Clean the remote control using non abrasive detergents
Follow instructions below for replacing battery.
8VLQJDVPDOOÀDWKHDGVFUHZGULYHUUDLVHWKHFRYHURIWKHEDWWHU\GRRU
A
LQ
order to access the battery compartment. FIG. 4.
Remove the battery and replace with Type A23 12V .
Negative end of battery should face the spring inside the remote.
Replace battery door and recycle old battery.
Blower On / Speed Selection
Press to power on blower and cycle through all six blower speeds.
Blower On / Power Off
By pressing , the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Delay Off
Lights On / Dim / Off
Switch lights On by pressing once, again to dim and again to switch Off.
Blower On/
Speed Selection
1
1
2
3
4
Blower On/
Power Off
2
5 Min Delay Off
3
Lights On/Dim/Off
4
By pressing , the blower and lights will enter Delay Off mode. A dot will
appear in the lower right corner of the power pack display indicating the
function is on. The blower will change to speed 1 and shut down after 5
minutes.
A
-
+
REMOTE CONTROL FEATURES:
The RF remote control is equipped with a magnet on the back for easy
storage. The remote may be placed on any magnetic surface such as a
refrigerator or the Wind Crest remote holder, FIG. 3. The remote holder
can be inserted into a standard electrical outlet for easy storage. Note:
The remote holder does not charge the RF remote.
Maximum remote control communication distance is 15 feet from the insert.
SYNCHRONIZATION:
To create a unique link between your range hood and remote control please follow the below steps:
1. With range hood off, press and hold the “lights” button on the range hood until the letter “F” shows on the display screen.
2. Press the “lights” button on the remote, the lights on the hood will turn on. The synchronization is complete.
Features & Controls –
RF Remote Control
RF REMOTE FUNCTIONS:
FIG. 3
FIG. 4